Raspberry Pi 400 Computer Kit

Raspberry Pi 400 Computer Kit

Argon IR Remote for Argon ONE V2 and M.2 Cases

Argon IR Remote for Argon ONE V2 and M.2 Cases

Raspberry Pi Pico (Board Only)

Raspberry Pi Pico is a low-cost, high-performance microcontroller board with flexible digital interfaces. Key features include:

  • RP2040 microcontroller chip designed by Raspberry Pi in the United Kingdom
  • Dual-core ARM Cortex M0+ processor, flexible clock running up to 133 MHz
  • 264KB of SRAM, and 2MB of on-board Flash memory
  • Castellated module allows soldering direct to carrier boards
  • USB 1.1 Host and Device support
  • Low-power sleep and dormant modes
  • Drag & drop programming using mass storage over USB
  • 26 × multi-function GPIO pins
  • 2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels
  • Accurate clock and timer on-chip
  • Temperature sensor
  • Accelerated floating point libraries on-chip
  • 8 × Programmable I/O (PIO) state machines for custom peripheral support
$4.00
Availability: In stock
SKU
Rpi_Pico_Board
 

Raspberry Pi Pico is a low-cost, high-performance microcontroller board with flexible digital interfaces. Key features include:

  • RP2040 microcontroller chip designed by Raspberry Pi in the United Kingdom
  • Dual-core ARM Cortex M0+ processor, flexible clock running up to 133 MHz
  • 264KB of SRAM, and 2MB of on-board Flash memory
  • Castellated module allows soldering direct to carrier boards
  • USB 1.1 Host and Device support
  • Low-power sleep and dormant modes
  • Drag & drop programming using mass storage over USB
  • 26 × multi-function GPIO pins
  • 2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels
  • Accurate clock and timer on-chip
  • Temperature sensor
  • Accelerated floating point libraries on-chip
  • 8 × Programmable I/O (PIO) state machines for custom peripheral support

What is on your Pico?

If you have forgotten what has been programmed into your Raspberry Pi Pico, and the program was built using our Pico C/C++ SDK, it will usually have a name and other useful information embedded in to the binary. You can use the Picotool command line utility to find out the details.

Debugging using another Raspberry Pi Pico

It is possible to use one Raspberry Pi Pico to debug another Pico. This is possible via picoprobe, an application that allows a Pico to act as a USB → SWD and UART converter. This makes it easy to use a Pico on non-Raspberry Pi platforms such as Windows, Mac, and Linux computers where you don’t have GPIOs to connect directly to your Pico.

Resetting Flash memory

Pico's BOOTSEL mode lives in read-only memory inside the RP2040 chip, and can't be accidentally overwritten. No matter what, if you hold the BOOTSEL button when you plug in your Pico, it will pop up as a drive where you can drag a new UF2 file. There is no way to brick the board through software. However there are some circumstances where you might want to make sure your Flash is empty. You can do this by dragging and dropping a special UF2 binary onto Pico when it is in mass storage mode.

Write Your Own Review
You're reviewing:Raspberry Pi Pico (Board Only)
Your Rating